[ger21]

So you just sell "blanks", with no threaded mounts or adapters?
I've made a few of these a few years back, but was routing a pocket for a nut in the back, to mount them to the headstock.

 

[ger21]

You been following FLA threads? Nate is really getting slammed.

He shipped quite a few really bad machines, and really ruined his reputation.

 

[ger21]

That definitely makes it a LOT easier.

 

[ger21]

I had concerns about the bed being flat , and sure as heck this guys table had a strut that was welded in place higher than the others .

That's minor. Many people had twisted, non square frames, with non parallel linear rails, and gear racks out of alignment. He shipped several machines that were completely unusable. This is on top of the fact that he's always been terrible with support, and customer contact.