Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
195 Posts
shanohano said:
Hi Everyone,

I was wondering where I can get the other wrench used to hold the shaft when loosing the collet nut. Thanks for any assistance.
Hi, the "stamped" wrench that comes with the M12V (21 mm), and other tools, is not worth using (IMHO). Get yourself a 24 mm and a 21 mm wrench (sometimes reasonable at a swap shop etc.) Get someone to "thin" the end of the 24 mm wrench to 5 mm or less (0.2 in ±) and you will be able to use both wrenches the way Bob and Rick do to change bits.
Steveo
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top