Router Forums banner
Cancel

Mach3 or 4 vs UCCNC

7144 Views 3 Replies 4 Participants Last post by  difalkner, 
D
New cnc router will be up and running soon. Wondered if opinions and experience would be shared on these two softwares?

Advantages? Abilities? Use of penants and such?
Reply
Save
Like
1 - 4 of 4 Posts
T
DARRELL81,
I cannot speak for others, but also being new with CNC, i use Vectric Software. i have used Mach 3, but no nothing of UCCNC. I found for me it was and is easier to use the Vetric and that is also the software provided by the company who i purchased my machine. Not much help, I know, but my preference at this time.
Reply
Save
Like
MEBCWD
Darrell here is a post asking your question. Note what he says about missing Gcodes. https://en.industryarena.com/forum/mach-3-vs-uccnc-any-thoughts-experience--271970.html

Not sure if they would be a problem for you but it is worth looking into just in case.
Reply
Save
Like
difalkner
I'm fairly new to CNC but started with Mach4 controller software and the Ethernet Smooth Stepper for the interface. So far this has been reliable except for when I've done something to mess it up, but I guess that can happen with any software/hardware combination.

David
Reply
Save
Like
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top