Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,246 Posts
When our CNCs get stopped at a limit switch (by an inexperienced student), I tell linuxCNC to override the error and restart, and make sure the first jog move I make is away from the limit switch. Usually this works the first or second try. If not then turning off the controller and hand spinning lead screws does the trick.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top