Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
Advice for beginners: My Probotix Nebula got stuck at the far end of the table (y-axis) after I jogged it too far manually in order to put a large sheet on the table.

Homing or jogging did not get it unstuck. With homing it would even start to rattle. I found out from Probotix that you should home first for the limit sensors and even better that you can rotate the long lead screws by hand to get the machine unstuck. That worked
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top