[BThornton]

There is no such thing as a stupid question, right?

I am trying to make a rabbet cut on one edge of a board. But when I get to the end of the cut, if I keep pressure on the bearing of the bit in order to maintain the width of the cut at the end, I obviously get an ugly rounded rabbet (curved inside) when the bearing reaches the end of the board. Is there some kind simple jig, fixture, router guide, etc. out there that can fix this?

Thanks,

Bob

 

[BThornton]

consistent rabbet

Thanks for all of your responses. It's nice to know that I had actually already considered a few of them since they were pretty straightforward, which is something new since often the experts give me complex solutions that I don't understand and/or don't even have the tools for!

Thanks again,

Bob