Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5,299 Posts
Discussion Starter · #1 ·
Hi All,my Makita sander (76x457mm)will not go straight no matter what. It appears to have only one adjustment screw which almost sets it right,but as soon as I begin sanding again it runs off so that half of the belt is off the rollers.If anyone can advise me on how to fix this problem I sure would appreciate it.All the best,Jamesjj777746.

Makita 9910. Q980 70. 3 amp. 650 w 220-240 v 270M/min.
 

·
Registered
Joined
·
5,299 Posts
Discussion Starter · #4 ·
@stick 486.Thank you Stick,much appreciated. I previously replaced one belt but with another from the same pack & it also wandered half off so I will buy a better brand & see what gives. If problem persists,I shall try all your suggestions & surely one will remedy this tracking sob..Best wishes,James jj777746.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top