Router Forums banner

Making a downdraft sanding box

5892 Views 20 Replies 12 Participants Last post by  imaginationuninc
I'm guessing dust control goes under the heading of 'Shop Safety'...

Every time we sand anything at all we find that the dust is just too much to deal with and takes hours to clean the shop. So I decided a downdraft sanding box is needed. I've read how some say they don't work very well but I see plenty of how-to videos so someone must like them. Even if it only helped 25% it would be better but after building it and using it I can safely say it is catching at least 75% of the dust, if not more.

So nothing new or secret here, just a video documentation of how I built mine plus the slightly entertaining value of watching us work with a 4x8 sheet in a small shop.

  • Like
Reactions: 5
1 - 3 of 21 Posts
Dave that is another good video. Looks like a good project but I would have no idea where to store it when not in use. Maybe hinge it on a wall so it could be out of the way but be easy to swing it up when needed.
  • Like
Reactions: 1
Don the problem I see with mounting it on drawer slides is the working height of the top. I have enough problem with working on the top of a normal workbench but it could be on a drawer mounded shelf where it could be pulled out and raised up onto the top of the workbench. Problem there would be the top of the workbench would need to be cleaned off before you could use the table.

Oh one more possibility it could be hinged to your workbench on the end or back if your bench is not against a wall and mounted right would be higher than the top of the bench when in use or could be mounted where it is flush with the top. with the addition of the T-track it could be used to assist with glue ups. I kind of like this idea because both of my workbenches are on rollers and are usually never against a wall.
So maybe I need to rethink things because my way may be too high for my shop stool. :wink::grin:
1 - 3 of 21 Posts