Router Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
669 Posts
Discussion Starter #1 (Edited)
Here is a link to my other CNC carving on You Tube. Please note the infinite X,Y,and Z travel and simple tool change out. loading the software is done with Coffee and chocolate. it runs about 90 minutes than stops and BS's endlessly.. reboot, and start over.

Canadian Ninja Carving.. ( Parents were Canadian, hence the CNC).


Finish "CNC" carving is pictured below...
 

Attachments

·
Registered
Joined
·
31,264 Posts
you are so far above my pay grade Scott... WOW!!!!
 
1 - 5 of 5 Posts
Top