Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter · #1 ·
For Bob and Rick. Caught your show today. You were making an executive desk and I noticed you using a small metal bar or block for measuring the height of the router bit. Are these availabile for purchase or did you make your own? Looking forward to seeing the finish of the desk. Thanks.....DON
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top