Router Forums banner
Cancel

Measuring blocks

4947 Views 6 Replies 6 Participants Last post by  old55, 
D
For Bob and Rick. Caught your show today. You were making an executive desk and I noticed you using a small metal bar or block for measuring the height of the router bit. Are these availabile for purchase or did you make your own? Looking forward to seeing the finish of the desk. Thanks.....DON
Reply
Save
Like
  • Like
Reactions: 1
1 - 1 of 7 Posts
R
As seen on "the Router Workshop"!
A must for every shop!

Set of 5 sizes ranging from 1/8" to 1/2". Solid brass to protect router bits, complete with easy access holder indicating the bar sizes.

www.oak-park.com
look for "Brass Measuring Bars"

other on-line stores have then too......

Check here for some more thoughts on these
www.routerforums.com/showthread.php?t=171

Ed
See less See more
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top