Router Forums banner
1 - 3 of 3 Posts

· Premium Member
7 Posts
I discovered Microjig clamps last year when building jigs for some small side tables. Very easy it is to create a grid of 1/2” diameter 14° dovetail slots where part clamping might be needed: mortise and tenon jigs, tall vertical fence for the table saw and router table, drill press table and fence, the side of the work bench behind the side vise. I haven’t yet added them to an assembly table but that’s in the to-do list.

Here‘s the tenon jig:

Lots more examples in this album of jigs:

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.