Router Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
If anyone has a model A, cat. 680 Millers Falls router, could you tell me the size-thread for the collet nut? I have aquired one, motor works fine but the collet and nut are missing. Perhaps someone might know of a current day manufacturer with a compatible nut. Thanks in advance!
 

·
Official Greeter
Ross
Joined
·
11,623 Posts
Welcome to the forum Les, I’m sure someone will be along to give you a hand.
 

·
Registered
Joined
·
31,264 Posts
If anyone has a model A, cat. 680 Millers Falls router, could you tell me the size-thread for the collet nut? I have aquired one, motor works fine but the collet and nut are missing. Perhaps someone might know of a current day manufacturer with a compatible nut. Thanks in advance!
that router is in the vintage class of tools...
ebay may be your only hope..

using a thread gauge would give you the thread count diameter...


once you know that this place may be of some assistance...
 
  • Like
Reactions: dirt_dobber

·
Registered
Joined
·
31,264 Posts
one more thing...

Hello and welcome to the forums...
According to your icon window yur choosing to be known as N/A...
Welcome to the forums N/A...
 

·
Retired Moderator
Joined
·
16,385 Posts
Hi Les and welcome. You have to match thread pitch and shaft diameter on the nut and cone diameter and taper. I think most or all router makers these days source them out. I don’t know if that was the case that long ago or not. You could try looking at elaire.com and look through their offerings and see if one looks like yours. If it looks like it then chances are good that it is. I was looking through them and saw that a Bosch WK series looks exactly like the one for my DeWalt 610 model.
 

·
Registered
Mike
Joined
·
3,959 Posts
Welcome to the Router Forums Les.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top