Hi woodendigits
10" Blades don't flex on the ends
,,,, try this Clamp the wood in place then make a new test cut.
It may be bad blade with one or two carb. tips not true or bad Set on the blade also make sure the washer that holds the blade on the saw is the right one and in the right place.
Pop in a standard blade from your table saw and test cut some stock,if you have a
7 1/2" / 8" blade try it 1st.
Bj
10" Blades don't flex on the ends
,,,, try this Clamp the wood in place then make a new test cut.It may be bad blade with one or two carb. tips not true or bad Set on the blade also make sure the washer that holds the blade on the saw is the right one and in the right place.
Pop in a standard blade from your table saw and test cut some stock,if you have a
7 1/2" / 8" blade try it 1st.
Bj
