Router Forums banner
1 - 2 of 7 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
Howdy all.
I picked up a rather cheap Delta miter saw to help myself out around the house with the baseboards, as well as any other projects I see fit. After spending quite a bit of time setting the blade square to the fence with the use of a machinist's square, I'm still getting weird cuts. It actually looks rounded on both sides of the cut when I hold my square up to it. Did I just do the wrong thing by purchasing one of these? Or is it possible for the included manufacturer's blade to flex when it hits the wood? Any thoughts?
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.