Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #3 ·
The truck is about 12 inches long X 6 inches tall and 7 inches wide.
The tires are made in two pieces. I used a router table with a 1/4 inch straight bit using a miter gauge and a jig I made. I cut each 1/2 one at a time then glued them together. I have made them on a bandsaw with the table tilted and a tablesaw with the same jig I used on the router table.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top