Router Forums banner
1 - 1 of 10 Posts

· Registered
10 Posts
Discussion Starter · #1 ·
I'm looking to up date my routers for table mounting. I have used an old B/D until it is worn right out, and have an old Craftsman 150 that the hight adjustment ring is less than satisfactory on.
I think that the ability to chuck 1/4 and 1/2 inch bits is a must but after that I don't know which features are important, and which are just window dressing. Variable speed?
I think that the Oak Park table top system is the best, most simple system for old timers like me!---Jack
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.