Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
Hi all,
I just build a new router table and I now need to mount my M12V to my plate. I believe the stock machine screw on the bottom of the plate are M5X14. Does this stand for 5mm X 14mm?

I have mounted routers to plates before but is there a how to doc somewhere that explains allignment and mounting to a plate for the M12V. I am always looking for the simplest methods.

Thanks,

deck
 

·
Registered
Joined
·
55 Posts
Discussion Starter · #3 ·
Thanks Bj,

I have seen these sites before. They are pretty interesting. I figured out to use the plastic plate on the bottom of the router for allignment. As far as the screws go I assume they are 5mm. I bought some today at lunch and will try tonight.

As for the woodshop demos sites......I see he uses a lot of girls in his demos :).



deck
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top