Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there, I'm new to the forum and the CNC Router world. I'm having trouble getting any information on what air compressor I can get by with for this machine. It seems like the scfm numbers are so high. I was wondering if I could get by with maybe a 30 gallon Husky or something with about 6 scfm @ 90 psi???
Any input would help me out.
Thanks!!
 

·
Registered
Joined
·
265 Posts
the manufacturer should have the air specs required for the machine. i am not familiar with the typical needs of a plasma cutter. but, whatver the mfr recommends is what you need to consider.

you are right, there is going to be a pressure and flow rating that you need to meet or exceed. personally, i would exceed it some.
 

·
Official Greeter
Joined
·
19,739 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top