Hi Terrence
The A-1 is a very simple plain rip saw with a fixed blade (no tilt, only rise and fall) and a simple rip fence. If you can use a table saw, any table saw, then the A-1 is no different. It is, however, very, very old - at the very least something like 20 years old, probably much older as Multico seemed to have sold very few of these from the late 1960s. You are unlikely to get a manual from the manufacturer, either. Multico at Redhill in Surrey went to the wall in the 1980s and were bought-out by somebody who moved the operation to Harlow in Essex where they remained until the operation moved once more to France in around 2003/2004. With the move to Harlow ALL the old range of machines was dropped (including the table saws) was dropped with the exception of the newly developed (at the time) range of square chisel morticers. I doubt that spares and manuals would have survived the move, but you might always get lucky.
I am interested in how you are going to take it to "bigger jobs". Unless you have managed to find yourself a 110 volt induction motor and DoL starter with brake (the A-1 came only with 240 volt or 415 volt, and never a brake - too old for that) you probably won't be allowed on the job with it, assuming that it's a proper site job and you're a working carpenter or tradesman. Personally I wouldn't fancy trying to lug that much weight around on site, especially given how limited the capanility of thesaw is
Regards
Phil
