Router Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
2,603 Posts
Discussion Starter · #1 ·
I bought this table to have a flat surface to work on and hold wood while I work. I installed 4 drawers that I can pull out from either side to put junk in. On the end of the table, I fixed it so I could hold boards on edge to do whatever needs to be done. So far I have enjoyed having a table that is flat so I don't have to use my table saw.

The end is made two pieces of 3/4" ply (the good stuff) that are glued together so it's 1 1/2" thick. I sawed it in half so I could drill the holes with my drill press.






 

·
Registered
Joined
·
31,264 Posts
nicely done..
 
  • Like
Reactions: hawkeye10
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top