Neat idea, might have to take a better look at that soon. Thanks for posting, Ronnie!
David
David
Neat clamping here
Well I came across this post that seemed rather interesting.
Some day, maybe sooner than rick i'll be getting a CNC.
So i'm looking at tops deciding between vac or clamp or hybrid
I found this guy....
Meet the quoin
![]()
Really neat clamping going on there, no?
Found here at Bar-Plate but im sure there's other sites out there.
Ok, they seem to cost a good quoin err coin. But....
For the price to do a couple of clamps to do the same job
balances it out. They seem low profile too.
Oh, if this has been posted before than oh well.
It will help someone new probly.
Hah... that BarPlate website has some interesting goodies :wacko:
Oh yea, Morning all
Hah... just found this video. Similar techniques:
Some day, maybe sooner than rick i'll be getting a CNC.
So i'm looking at tops deciding between vac or clamp or hybrid
I found this guy....
Meet the quoin
Really neat clamping going on there, no?
Found here at Bar-Plate but im sure there's other sites out there.
Ok, they seem to cost a good quoin err coin. But....
For the price to do a couple of clamps to do the same job
balances it out. They seem low profile too.
Oh, if this has been posted before than oh well.
It will help someone new probly.
Hah... that BarPlate website has some interesting goodies :wacko:
Oh yea, Morning all
Hah... just found this video. Similar techniques:
1 - 3 of 3 Posts
1 - 3 of 3 Posts
