Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a noname router and I need a 1/4 collet for it the one i have is cracked .
it is like the #2 at this web page

http://www.woodhaven.com/FAQShow.aspx?ID=1748
(Internal Spindle Taper)

The threed size is 7/16 for the collet and 3/8 for the router shaft im looking for a web site selling them or some one that has eather the 1/4 collet or the whole set for sale that would go on the 3/8 router shaft.
the router shaft is a therded 3/8 shaft
 

·
Registered
Joined
·
143 Posts
Hi tdd,
I have an El Cheapo 1/4" pneumatic die grinder that has this type of collet on it. I think I paid something like $14 or $15 for it, and that included an assortment of mounted stones. I'm not sure where I bought it though. Maybe a flea market or bargin store. Hope this helps........Chuck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top