Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 4x4 standard cnc router from cncrouterparts.com and I cannot get the motors to have movement. This is the link to the electronics kit with the 3/8" motors: http://www.cncrouterparts.com/4-drive-diy-nema-23-electronics-kit-p-75.html I cant figure out if its a wiring issue or an issue with how I set up mach 3. Although, the limit switches are working fine. Any tips, help, etc?? Thank you!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top