Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello all, trying to figure out how to replicate this bottom rail edge profile. Looks like a standard bead but it has a straight cut at the top as well.

If anyone knows what bit to use here that would be much appreciated. Also I suppose I could just do it in two passes with a straight and a bead bit.

View attachment 399271
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #9 ·
Hello and thank you all for the welcome and the responses.
It's definitely not two pieces of wood.
I will be replacing a large section and adding another 25 feet or so of railing.
I think I will first try the table saw first for the ledge and then use the router for the bead.
Will report back with how it goes.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top