If that’s an existing profile that you need to match I would say it’s a custom grind probably for a moulding head. Fingernail and table edge profiles are similar but tend to be more like finger/table edge profiles where that seems more like srtraight slopes of different angles. I can’t tell without having it to measure but the slope to the left side might be 45* with the secondary slope around 20-25*. I have some raised panel bits approximately that slope but they have guide bearings and I think you would need them without. You might be able to find bits to do that but I think it would be a 3 pass operation.
Alternatively you could cut a section off that and send it to Whiteside and have them grind you a custom bit.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
