Router Forums banner
1 - 1 of 12 Posts

· Retired Moderator
16,386 Posts
Theo if you use a 1/2 for both sides with one side having a fillet and the other none then you'll necessarily have a flat in the center. If you use a 3/4 for both sides with one having a fillet then the curve will be off a bit, i.e. not a smooth radius. To have a smooth (but not uniform) radius you would need to leave a 1/4" fillet on one side with a 1/2r and the full curve on the other with a 3/4r. You can vary the radius or the fillet and get a number of different combinations but the only truly uniform cure would be 3/4 on both sides and no fillet. I don't know what you are aiming for so I don't know what's acceptable but just pointing out some of the issues.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.