Router Forums banner
1 - 1 of 14 Posts

· Super Moderator
5,824 Posts
I have the little DeWalt and have been happy with it. The fixed base is mounted on a board for flush trimming cabinet parts. I use the plunge base for everything else.

I don't have any experience with any of the other compact routers.

The pictures show how I used it to route dadoes using my exact width dado jig and a pattern bit.

Hope this helps.

EDIT: Yes, the holes are on both sides of the base so the guide rods can extend out the opposite side of the the base. I just looked at it.


1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.