Router Forums banner
1 - 1 of 22 Posts

· Registered
23,206 Posts
I have Jet parallel clamps. They have a flat back so they sit right up on a table. The Jet clamps have a quick release lever. The Woodpecker bars hold the clamps, not the workpiece. So drilling holes in a 2x4 or 1x, then sawing out the opening with a band saw to hold the clamps sounds like a cheaper solution to me. You can make it as long as you want for table and counter top lengths.

I have a couple of Woodpecker items that are terrific, their router mounting plate and their table saw setup jig for measuring fance-blade-miter slot alighment. But by and large, their stuff is iffy usefulness and way too high priced to suit me.
1 - 1 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.