Router Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,002 Posts
Here is my new computer center not totally finished. I did not have much floor space so design to go up. Built with 3 2o inch by six foot handy panels .
That idea came from MT Stringer. Saves a lot of glue up and uses solid wood. Here is my picture.
 

Attachments

·
Registered
Joined
·
15,459 Posts
Great stuff to work with, eh? :)
If you can figure out a way to install a horizontal back panel, at least 8" tall, spanning side to side you'll have a much safer structure; not as much chance of it deforming into a parallelogram or worse.
At least one drawer would give you a place to stash all the small bits, which if my desk is any example seem to breed at night.
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #3 ·
Shelves are 2x stock through bolted with 1/2 carriage bolts mdf on top. No wobble at all . You could stand on the shelves. and they will not deform. plus the face frames are pocket holed between sides
 

·
Super Moderator
Joined
·
5,814 Posts
Good job. And you still have room to store more stuff. Those project panels are really handy.
 

·
Registered
Paul
Joined
·
2,008 Posts
Looking good, Gary. I like those panels too... made several projects out of them.
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #6 · (Edited)
I've ordered a power surge multi port to fix wiring rats nest. Next going to make a pantry out of a couple more of those handy panels.
Thanks for all the kind remarks. Then get a back put on maybe drawers in bottom right side.
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #8 ·
Here almost complete. I made 3 drawers as someone had suggested. I need to put poly on the drawers. After poly is applied need hardware put on the drawers and put a back on the case. Here is latest picture
 

Attachments

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #9 ·
Here almost complete. I made 3 drawers as someone had suggested. I need to put poly on the drawers. After poly is applied need hardware put on the drawers and put a back on the case. Here is latest picture .
 
1 - 9 of 9 Posts
Top