Router Forums banner
1 - 1 of 7 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
A dated design on a new drawer face to match existing design is holding up an entire kitchen job. This is not a unique pattern. Looking for the router bit(s) to make it. I think I might have found it on this site. There are not many drawer faces mass produced that had rounded inner edges but I think this one was more common just very dated.

Revere Mitered 3/4" Routed Drawer Front

Rectangle Wood Major appliance Ceiling Transparency
Rectangle Wood Composite material Gas Gadget
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.