Router Forums banner

New member

1011 Views 10 Replies 9 Participants Last post by  Tabasco
Hello,

I have a Shark II CNC running VCarve 9.511 software.
1 - 11 of 11 Posts
Tabasco

Hello I'm new here.
Hi Tabasco and welcome. We have some pretty knowledgeable members with CNCs.
Welcome to the forum! When you get a minute complete your profile with location so it shows in the left panel. You can add your name to your signature line and it will show in each post.

Post photos of your CNC, shop, projects, etc. when you're ready.

David
Welcome to the forum
Welcome to the forum.
Welcome Tabasco
Hello,

I’m having no luck trying to do a letter in a single pass and getting a decent result. Let me explain…I have tried the single pass font in VCarve but unfortunately using the only font sets they have puts the letters so close to each other they are not “separate”. I have already contacted them and they do not have a way to do what I looking for. I want to be able to set the distance “between letters. Does anyone have any ideas how I can pull this off?
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top