Router Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I finally ordered my router table from Incra (combo 3 "the works) with LS25 fence, Mast-R-Lift II lift, and JessEm PowR Tek router that I have been working on getting for the last year.

I am also about 80% finished building my DIY CNC (MPCNC) with 27" by 42" cutting area. I printed all the fittings on my 3D printer and redesigned quite a few of the parts along the way to suit my needs. I am new to 3D printing/3D modeling as well so this has been quite the learning experience.

There seems to be a lot of great information here. I'm looking forward to learning a ton!

-Trevor
 

·
Registered
Joined
·
31,264 Posts
welcome to the forums Trevor...
 
  • Like
Reactions: trevordj

·
Registered
Rick
Joined
·
17,588 Posts
Welcome to the forum Trevor :)
And thank you for filling out your profile. Looking very forward to seeing your cnc router table.
Great choice on your router table also. I bought the same setup as you, but never got around to assembling it . Will let you do it first so I can learn lol
 
  • Like
Reactions: trevordj

·
Super Moderator
John
Joined
·
6,973 Posts
Hello and welcome to the router forum Trevor
 
  • Like
Reactions: trevordj
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top