[reuelt]

Hi everyone! I am trying to find which insert plates will work with the Skil 1810 router. The mounting screws seem to be offset somewhat, but all of the insert plates that I look at don't look like they would allow me to screw it to the plate.

Not wanting to spend a lot and don't have time right now to make one.

Any help would be appreciated.

I would simply buy one at Amazon with FEWER "predrilled holes" and drill 4 countersunk holes to match my router
e.g.

Amazon.com: PIAOPIAONIU 1 Pcs Aluminum Router Table Insert Plate for Popular Trimmers Routers DIY Woodworking with Rings and Screws for Woodworking Benches Router Table Plate Mounting Base Plate : Tools & Home Improvement

Buy PIAOPIAONIU 1 Pcs Aluminum Router Table Insert Plate for Popular Trimmers Routers DIY Woodworking with Rings and Screws for Woodworking Benches Router Table Plate Mounting Base Plate: Templates - Amazon.com ✓ FREE DELIVERY possible on eligible purchases

www.amazon.com

or

Aluminium Router Table Insert Plate for Woodworking Benches Router Plate Wood Tools Milling Trimming Machine, Red, 13inches (big) - - Amazon.com

Aluminium Router Table Insert Plate for Woodworking Benches Router Plate Wood Tools Milling Trimming Machine, Red, 13inches (big) - - Amazon.com

www.amazon.com

 

[reuelt]

It does not come pre drilled for your router. Note that the poster said you will need to drill your own holes. If you do this you should use a drill press. It will take two different bits, a smaller one just a little wider than the screws/bolts that hold the router to the plate. A larger one set to a depth just slightly larger than the head of the bold. To place the holes, remove the router base and mark the locations of the holes onto the plate.

If the mounting screws have a tapered head, you will have to get the hole precisely placed. That's why pre-drilled is so nice. Check Oak Park first.

BTW welcome to the forum.

I hope Oak Park already has insert plate for the Skil 1810 with screws holes in trapezium pattern.

 

[reuelt]

Not so hard to fit a router to insert plate.
Take off the sub-base from the router.
Mount the plastic insert + a 1 3/8 Porta Cable Style Guide guide bush. There are all self aligned..
In this case,
The RT0700C clone sub-base also fits perfectly into 1 3/8 guide bush. So router would also be aligned.
Carefully mark 4 holes with fine marker
Drill 4 countersunk holes on drill press.
Quite easily done.

(I got the clone router trimmer for only $AUD125 with 3 bases + accessories.
Makita RT0700C, and 18V Makita + 18V and 36V Hikoki (Metabo-HPT) Router-trimmers will all fit those bases perfectly. It also mean that Makita, Hikoki (Metabo-HPT) router-trimmers will all fit the VFD drive mounting block of my CNC machine UNCHANGED)

 

[reuelt]

I uploaded Skil 1810 1815 1820 1825 manual
here:-

Skil 1810 1820 1820 1825 manual

Skil 1810 1820 1820 1825 manual - English

www.routerforums.com