Router Forums banner
1 - 2 of 2 Posts

·
Administrator
David - Machinist in wood
Joined
·
4,267 Posts
Welcome to the forum, Ross! Does your machine use belts, gears, direct drive, etc.? Is anything slipping? Does it do this in the same place each time? Can you run a toolpath where you know it slipped but do it in the air, not cutting anything, and see if it slips with no load?

David
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top