Router Forums banner
1 - 1 of 1 Posts

·
Registered
Mike
Joined
·
3,953 Posts
If everything is tight on your machine(no worn parts and properly adjusted), it might be that you are exceeding the cut limits of your machine. If the project blank is not placed on the bed where the cut area of the toolpath is inside those limits then it could be losing steps when it exceeds the limits.
 
  • Like
Reactions: difalkner
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top