Router Forums banner
1 - 2 of 7 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
Hi Everyone,
Just joined and wanted to make a quick introduction. My name is Pat O'Connell, I have a small shop in Oak Park, Michigan, been working with routers for about 40 years, primarily with acrylic plastic (AKA Plexiglas, Lucite, etc.) as well as polycarbonate and other sheet plastics. It's my favorite tool in the shop!
If anyone needs tips for using hand held or table mounted routers for working with plastics, let me know and I'll offer any help/advice that I have. Same goes for table saw and drilling. Thanks again, looking forward to participating!
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.