Router Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Good morning,

I'm a new to woodworking participant here and have a need for routing with my current project. I have a craftsman 320 router and was going to round off a corner of a 4X4 and discovered that the plastic base of the router doesn't let me retract the router to where I'm only using the round cutter since I don't want to have that lip at the top... just a smooth larger radius (I'm assuming here) as compared to the 1/4" roundoff...

Am I to assume that the plastic base is removed when you use this large cutter?

Much Aloha... Tom
 

·
Registered
Joined
·
10,671 Posts
Greetings Tomand welcome to the router forum. Thank you for joining us, and remember to have fun, build well and above all be safe.
 
1 - 2 of 2 Posts
Top