New Woodworker

1229 Views 5 Replies 6 Participants Last post by Joe Lyddon, Mar 30, 2007

ronaldskypilot

Discussion Starter · Mar 26, 2007

Ron Pilot, New In Woodworking. Have Many Tools But No Skills.
Trying To Learn How To Use A Table Router And Still Retain All My Fingers.hobbie Is Flying Small Planes

Save

1 - 6 of 6 Posts

Welcome Ron! if you haven't yet check out the Router Workshop on the Woodworking Channel:
http://www.thewoodworkingchannel.com/

You will find some great uses for the router table and routers in general and do it safely. Learn from the some of the best. Lots of good folks here to help you as well. Your other hobby isn't a cheap one either!

Corey

Save

curiousgeorge

· #3 · Mar 26, 2007

Welcome Ron. You can learn a lot here so fly right in.

Save

Don Hurley

· #4 · Mar 26, 2007

Welcome

Hello and welcome,

This is a great place to learn and grow. Ask questions and you shall receive.

Again welcome,

Don Hurley

Save

Dr.Zook

· #5 · Mar 27, 2007

Welcome Ron the pilot, to the Router Forums. Always a pleasure to welcome newbies You can learn a lot from our experienced woodworkers. You have landed (pun intended) in the right forum to learn, so be "SAFE" and enjoy your new hobby.