Router Forums banner
1 - 1 of 4 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
greetings all, very new to the concept of routing so looking for advice on a project i been tasked with, need to find a way to make a few dozen poker chip trays to replace broken plastic ones with timber ones, i'll pop a couple of pix on to give a rough idea but don't have dimensions yet, bearing in mind the only routing i have done are rounding over edges and slots for kitchen worktops any advice would be appreciated :))


1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.