Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just purchased a PC 892 from the local box mart. Now, what's next? I know I'll need a table (there are directions on a cd that came with it but have not looked at them yet) and a plunge attachment. Not sure what bits would be good to start with. I plugged it in and it went wheeeeeeeeeeeeee!!!! so I'm assuming it works until I have all the parts to make it useful.

Any suggestions?

:D
 

·
Registered
Joined
·
10,714 Posts
Hello Artcwolf and welcome to the forums. What's next, depends on what you decide to do or make with your router. A few simple bits to start with, again depending on what you decide to do. When you decide, let us know and we can be more specific. Be safe and enjoy.

Dave
the "Doctor"
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top