Router Forums banner
1 - 1 of 16 Posts

· Registered
4,380 Posts
For what you are describing, a Probotix would do you good. I have a Nebula and would get another machine from them in a heartbeat except I do a lot of 3d work, and I need a faster setup using rack and pinion.

Edison Auto is at the Vectric conference and says Probotix is also coming out with a laser attachment that can be used on their machines. Check with Mark for the details. And don't forget the cost of the software, too.

Vectric, in my opinion, is a lot easier to work with than Fusion.
  • Like
Reactions: whimsofchaz
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.