Router Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello!
Glad to have found this forum. I recently started getting back into woodworking and wood carving.

I recently picked up a Freud 1702 on special at Lowes....My immediate need is to find or make a router table preferably using Freuds micro-adjustable fence as I will also use it for edge-jointing. I found the 1700 template on this site (thanks). Anyone have quick plans to make a router table...? Perhaps one that will fit on the end of a Ridgid TS3660 table saw?

Many thanks,

- TS
 

·
Registered
Joined
·
312 Posts
TS,

Welcome to the group! The Freud RTP1000 table comes with a plate that is pre-drilled for your router and with the SH-5 micro-adjustable fence. Even if you chose to not use the table, the plate and fence might make it worth considering.
 
1 - 3 of 3 Posts
Top