Router Forums banner
Cancel

Posts by doc8254

Jump to Latest Follow
1 - 2 of 6 Posts
D

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
After sealing the Mahogany Humidor I am building I applied Zar oil based stain as instructed only to have the top surface dry with blotches. The sides are fine!
I have sanded it with 120 grit and reapplied the stain with no change. What can I do to correct? Doc
 
D

· Registered
Joined
·
16 Posts
Discussion Starter · #5 ·
I resanded the surface with 120 and got back to the raw surface. Applied a conditioner the another coat of stain. It turned out nicely! Another coat to darken a bit then I can finish the project. The odd thing is that I'm built another at the same time from the same board and it turned out fine! Go figure?
 
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
5 Replies
5 Participants
Last post:
TwoSkies57
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top