Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I was 2/3 into a carving project and the power to my Oliver 1013 was interrupted. Is there a possible exact restart procedure. Or due you just reload your start point and hope for the best. Also is there any one selling the 1/50 carving bit any more?
 

·
Registered
Joined
·
31,264 Posts
can't be of help to you but can I suggest a UPS for the next time???
 

·
Retired Moderator
Joined
·
16,385 Posts
Hi and welcome. The guys will be able to tell you will probably want to know what software you are using.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top