Router Forums banner

Oliver 1013 power interuption

575 Views 3 Replies 4 Participants Last post by  old55
I was 2/3 into a carving project and the power to my Oliver 1013 was interrupted. Is there a possible exact restart procedure. Or due you just reload your start point and hope for the best. Also is there any one selling the 1/50 carving bit any more?
1 - 1 of 4 Posts
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.