Router Forums banner

Ooznest Workbee CNC 4th axis wiring

3272 Views 5 Replies 5 Participants Last post by  old55
Hi,
maybe someone have 4th rotary axis installed with their Workbee CNC? I'm planning on buing one from Aliexpress and just wonder maybe someone could direct me to any tutorial how to wire and set it up as i spent significant time searching but was unable to find any relevant info online..
My Workbee runs on Duet controller and rotary attachement is same as from this Aliexpress listing:

Any help will be highly appreciated
Thanks
1 - 6 of 6 Posts
Welcome to the forum! My first question would be about the driver required for this stepper motor; is there a dedicated driver or will you be piggybacking off another driver (X or Y)?

David
Hi David,
CNC's runing of Duet controller which have 5 integrated motor drivers.

you may want to verify that the controller can handle the current needs of the 4th axis stepper motor:
"Each driver can control up to 2.4A, this is enough for all NEMA17 Stepper Motors and most NEMA23 Stepper Motors"
Welcome to the forum.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top