Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
For my next project I bought Mike Pekovich's plan for the Essential tool chest. It should be a good learning experience. Lots of hand cut dovetails, wedged through mortise and tenon and panels with rails/stiles.

I have four 3/4" thick panels to glue up. Joining a 7 1/2" to a 5" maple board to give me 12 1/2" wide by 24" long. I am using parallel clamps, a wood caul and c clamps on the ends to hold the panels aligned. I don't have a biscuit jointer.

Does anyone have plans for a glue up table? or other suggestions where/how to put the clamps on. This is working but there must be a better way.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top