Router Forums banner
1 - 1 of 1 Posts

·
Retired Moderator
Joined
·
16,385 Posts
Splining will help with alignment and cutting the grooves on a TS is fairly quick work. !/4 ply would make a good spline. Otherwise, you are doing what most of us do when we glue up a panel. One issue if you will be doing a raised panel though is whether you will wind up cutting into a biscuit or groove.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top