[Herb Stoops]

Here are the pictures of the smaller IPAD?TABLET build.

I apologize for the blurry picture of the toothpick dowels I used to hold the back support aligned while the glue is drying.

Herb

 

[Herb Stoops]

Before Stick jumps all over me for the bar clamps from HF, these are US made bar clamps.

Herb

 

[old55]

Looking good Herb.

 

[MEBCWD]

:laugh2:Herb I have a mini router table just like the one you have in the 5th picture!:laugh2:

 

[Stick486]

wow Herb...
now look how great they turned out w/o any HF...

 

[TenGees]

Looking good, Herb. I guess you had to hide your HF clamps for the pictures.

 

[Herb Stoops]

:laugh2:Herb I have a mini router table just like the one you have in the 5th picture!:laugh2:

Sure handy little devils,aren't they.
Herb

 

[Herb Stoops]

Looking good, Herb. I guess you had to hide your HF clamps for the pictures.

SHHHHHHHH...........not too loud. Sure miss the free flashlights and stuff tho.:laugh::laugh::laugh::laugh:
Herb

 

[papasombre]

May you give more details about the way you attached the trimmer to the vise in picture 5?

 

[Herb Stoops]

May you give more details about the way you attached the trimmer to the vise in picture 5?

To answer your question, I set the PC router upside down on the work bench and then clamp the base in the vice. The PC router has a sort of square shaped base that just fits into the vice.

A person could make a clamping jig that fits around the router motor and clamp it in the vice, or build a small box that a trim router could be mounted inside and turned upside down with the bit sticking through the bottom.
Herb